The van diesel heater glossary

Dosing pump, standpipe, E-08, purge: diesel heater manuals and listings speak their own language. This page explains the 29 terms you will meet most often around a van heater, each in a few sentences and backed by the numbers of the heaters in our lineup.

These are the words that keep turning up in heater manuals, Amazon listings and van build forums, sorted alphabetically with digits first. Each entry points to the guide that goes deeper, so you can read the short version here and the long one there.

The figures come from the five heaters we compare in our roundup of the best diesel heater for a van. You can see them side by side in the comparison table on the homepage.

#

12 V battery
The house battery that powers the heater’s fan and glow plug. Its running draw is low, often 1 to 3 A at 12 V, but each start pulls far more for a minute. A tired battery is the usual reason a heater won’t light; see how much battery a diesel heater uses.

A

All-in-one heater
A portable box holding heater, tank and controls, such as the VEVOR with 5 L, our top pick, or the HCALORY with 7.9 L. It still makes exhaust, so the box sits outside and only warm air comes in through the duct. Why that matters is in our carbon monoxide guide.
Altitude mode
A setting that trims the fuel to suit thinner air. Without it a heater set for sea level runs rich and smokes. The Espar senses altitude itself up to 18,000 ft, the VEVOR split and OBAKL adjust up to 18,045 ft and the HCALORY to 16,400 ft, while others need a manual switch; see running a heater at altitude.
Amp-hour (Ah)
The unit for battery capacity, one amp drawn for one hour. A heater pulling 2 A for ten hours uses about 20 Ah, plus the extra for each glow-plug start and purge. Leave a healthy margin, because a cold battery gives less than its label. The overnight arithmetic is in our battery guide.

B

BTU
British thermal unit, the energy that warms one pound of water by 1 °F; heat output is quoted in BTU per hour. One kilowatt is about 3,412 BTU, so the Espar’s 2 kW listing reads 6,824 BTU. Makers of these heaters lead with kW, and our van heater size guide works in both.
Burner screen
A mesh sleeve in the chamber, beside the glow plug, that spreads fuel so it vaporizes and lights evenly. When soot clogs it, starts fail and the flame runs dirty. Owners pull it out to clean or replace it during a service, a job covered in keeping a diesel heater clean.

C

Carbon buildup
Soot that coats the chamber and exhaust when diesel burns without enough air or heat. Long nights on the lowest setting cause most of it, so run on high now and then. The HCALORY has a one-tap carbon-cleaning routine, roughly 20 minutes long. Prevention and cleaning are in our white smoke and carbon guide.
Carbon monoxide
A colorless, odorless gas from burning fuel that takes the place of oxygen in your blood. A sealed diesel heater keeps it outside, but a leaking exhaust, a cracked exchanger or an outlet under a door can let it in. Where it leaks is the subject of CO and your van heater.
Ceramic igniter
A ceramic element that lights the fuel, a tougher cousin of the metal glow plug. The VEVOR all-in-one lists one for cold starts. It still draws heavily for the first minute, so it needs a healthy battery. If it fails, work through eight fixes for a heater that won’t start.
CO alarm
A separate battery-powered detector that sounds when carbon monoxide builds up. Mount it in the sleeping area and test it often. A heater’s own CO sensor, as on some VEVOR boxes, guards the heater’s surroundings and is no substitute. It is the first item in our nine safety rules.
Combustion air intake
The pipe that feeds outside air to the flame, separate from the cabin air. On a split heater it runs through the floor, ending away from the exhaust so the heater never breathes its own fumes. Never let it draw from inside. Routing tips are in installing a heater through the floor.
Cool-down purge
The minutes after you switch off, when the pump stops but the fan keeps running to cool the exchanger and clear the chamber. The glow plug often heats again to burn off leftover fuel. Never cut power mid-run or mid-purge, a rule explained in diesel heater safety in a van.

D

Dosing pump
The solenoid pump that ticks fuel to the heater in measured pulses. It mounts close to the fuel source, angled about 15 to 35° upward and rubber-mounted against ticking. Espar damps its piston for a quieter click. Placement is covered in our fuel supply guide.
Ducting
The flexible hose that carries warm air to an outlet in the cabin. Short runs with few bends keep the airflow strong and the fan quiet. With an all-in-one box it is the only part that enters the van. Ducting tricks are in six ways to a quieter heater.

E

ECE approval
European type approval under ECE R122, shown as an ECE mark. The Autoterm Air 2D carries it; cheap unbranded heaters often don’t. In the US it is a useful sign of a tested design rather than a legal requirement. Brands are weighed in Espar, Webasto or a budget brand.
Error code
A code such as E-01 or E-08 on the controller, telling you why the heater stopped. Codes differ by brand, so check your manual, but low voltage and failed ignition are the usual meanings. Owners of the VEVOR box report codes and shutdowns. Decoding them starts in when the heater won’t start.
Exhaust silencer
A small muffler on the exhaust pipe, mounted below the floor on a split heater. It takes the edge off the pulsing roar outside, which campground neighbors appreciate. It gets very hot, so keep it clear of fuel lines and wiring. More noise fixes are in our quiet heater guide.

F

Floor plate
The flat mounting plate and gasket that seal the heater to the van floor, with holes for the exhaust, intake and fuel line. A flat, airtight seat is what keeps exhaust out of the cabin. Ribbed van floors often need a spacer first. The full method is in our installation guide.
Fuel filter
An inline filter that keeps grit and tank debris away from the dosing pump. The Espar kit leaves it out, so add one, and budget heaters often hide a tiny one inside the pump inlet. A clogged filter starves the flame and causes smoky, failed starts; see our fuel supply guide.

G

Glow plug
The heating element that lights the diesel mist at each start and often helps burn off fuel during the purge. It is the biggest electrical load, which is why starts stress a weak battery. The HCALORY pre-heats its plug for one minute. Testing and replacing one is part of our eight start fixes.

H

Heat exchanger
The finned metal body that lets the flame heat cabin air without the two touching. A sound exchanger is the main reason a sealed heater is safe; a cracked one can leak exhaust into your air. VEVOR lists sandblasted aluminum, HCALORY an SUS310S alloy core. Warning signs are in where CO leaks.

K

Kilowatt (kW)
The unit of heat output, about 3,412 BTU per hour. An insulated campervan usually needs about 2 kW. An 8 kW label is marketing, since 0.62 L/h of diesel at roughly 10 kWh per liter is near 6 kW of fuel energy (our arithmetic). Sizing is in what size heater your van needs.

L

Low-voltage cutoff
A protection that stops the heater when voltage sags too far, usually with an error code. It saves the battery and the glow plug, but it can strike at 3 a.m. on a cold, cloudy week. Thin wiring makes it worse. Fixes are in our battery power guide.

P

Parking heater
The trade name for a fuel-fired heater that warms a vehicle with the engine off, which every diesel van heater is. Espar and Webasto built these for trucks long before van life, and the name still appears in manuals. Which one to buy is the subject of our buying guide on the homepage.

S

Split heater
A heater mounted inside the van, under a seat or in a locker, with its exhaust and intake through the floor. It is quieter and tidier than a box but needs drilling. The Espar, VEVOR 8KW and OBAKL are split kits; a cheap diesel heater can be one too.
Standpipe
A pickup tube fitted into the van’s own tank so the heater can draw from it. It stops short of the bottom, so the heater quits before the tank runs dry and you can still drive away. The Espar listing allows one but its kit list names none, while the OBAKL’s standpipe can connect to the van tank as a backup. Pros and cons sit in van tank or own tank.

T

Thermostat mode
A mode where the heater adjusts or cycles to hold a set temperature instead of a fixed pump rate. The VEVOR split holds 46 to 96.8 °F. Owners report wide swings and sensors that read off, so mount the sensor away from the outlet; see our guide to a quieter night.

W

Warm-air outlet
The grille where heated air enters the cabin. Aim it low and away from bedding, curtains and the thermostat sensor, and never block it, or the heater overheats and shuts down. The VEVOR split cuts out at 518 °F (270 °C) inside. Clearance rules sit in our safety guide.
Winter diesel
Diesel blended to stay liquid in hard frost, sold as winter grade. Summer diesel can gel in a cold tank and line, starving the pump. Never run a diesel heater on gasoline. Gelled fuel is one cause in when your heater won’t start; the fuel itself is described on Wikipedia.

Questions and answers

More questions about diesel heater terms

What is a dosing pump on a diesel heater?

It is the small solenoid pump that sends fuel to the heater in measured pulses, faster for more heat. That pulse is the ticking you hear at night. Mount it close to the tank, angled upward and on rubber, to keep it reliable and quieter.

Is an 8 kW diesel heater really 8 kW?

Rarely. A liter of diesel holds roughly 10 kWh, so a top fuel rate of 0.62 L/h equals about 6 kW of fuel input. That is our arithmetic, and it shows the 8 kW label is a marketing number.

What does the cool-down purge do?

After you switch off, the pump stops but the fan keeps running to cool the heat exchanger and clear the chamber. Cutting power during that time can overheat the heater and leave fuel behind, so always let the purge finish.

Do I need winter diesel for my heater?

In hard frost, yes. Summer diesel can gel in the tank and fuel line and starve the dosing pump. Use the winter-grade blend sold locally in cold months, and never run a diesel heater on gasoline.

What is the difference between a split and an all-in-one heater?

A split heater mounts inside the van with its exhaust and intake through the floor. An all-in-one puts heater, tank and controls in one box that stands outside and sends warm air into the van through a duct.